User Manual
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance
- 2 Mount Your Camera
- Hardware Installation
- Ceiling Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount the plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Attach the lining and lock it into the buckle on the base.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Wall Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Mount the lining and ensure that it is tightened up.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Start the Camera
- Ceiling Mount
- Waterproof Measures
- Waterproof Components for an RJ45 Plug
- 1. Attach the seal ring to the copper interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the Ethernet copper interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for an RJ45 Plug
- Hardware Installation
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
21
4 Access Your Camera
System Requirements for Your PC
Item
Requirements
Operating
system
Microsoft Windows 8/Windows 7/Windows XP
(32-bit or 64-bit). Microsoft Windows 7 (32-bit) is
recommended.
CPU
2.0 GHz or higher, dual-core. Intel i3 CPU or higher
are recommended.
Memory
At least 1 GB. 2 GB (or higher) is recommended.
Graphic
card
At least 128MB display memory. Mainstream
discrete graphics with more than 1GB display
memory are recommended. The hardware should
support DirectX9.0c.
Note:
Make sure that the latest driver is installed on
graphic card.
Sound
card
Required.
Note:
Two-way audio and voice broadcast require the
latest driver on sound card.
Network
Gigabit Ethernet network cards (or higher) are