User Manual
Table Of Contents
- 01-Front Cover
- 02-Title Page
- 03-Body
- 1 Appearance
- 2 Mount Your Camera
- Hardware Installation
- Ceiling Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount the plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Attach the lining and lock it into the buckle on the base.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Wall Mount
- 1. Locate the positions of the holes.
- 2. Drill holes on the wall.
- 3. Mount plastic rivets of self-tapping screws.
- 4. Mount the camera.
- 5. Adjust the monitoring direction of the lens (tighten screws after vertically adjusting the lens).
- 6. Mount the lining and ensure that it is tightened up.
- 7. Mount the transparent dome housing.
- a. Align the screw holes in the base, and tighten the two cross-recessed pan-head screws on the edge of the transparent dome housing to fix it, as shown by ( in the following figure.
- b. Align the grooves (non-tail cable grooves) of the transparent dome housing to the buckle of the base, and push up the dome housing to fix it, as shown by ( in the following figure.
- Start the Camera
- Ceiling Mount
- Waterproof Measures
- Waterproof Components for an RJ45 Plug
- 1. Attach the seal ring to the copper interface.
- 2. Mount the waterproof components. You can crimp the inner wires of the cable with the RJ45 plug first and then cover the waterproof components. You may also cover the waterproof components first.
- 3. Insert the cylindrical waterproof ring into bolt.
- 4. Insert the cable into the Ethernet copper interface and screw the waterproof bolt in.
- 5. Screw in the waterproof bolt lid.
- 6. Finish the waterproof installation.
- Waterproof Tail Cable
- Waterproof Components for an RJ45 Plug
- Hardware Installation
- 3 Set Your Camera over the LAN
- 4 Access Your Camera
- 04-Back Cover
