Manual

27
4B.1.1 Chamber Vacuum Packing Cycle
1 - Press the general switch (right side of machine) Ref. 8 Fig. 4B.1.2 in the ON
position. The display lights up and the word OFF appears
2 - Press the 1 button and put the machine in an ON mode.
The machine is ready for the chambervacuum packing cycle.
Check that the timing of vacuum packing and sealingtimes are optimal (the machine is
sold with preset vacuum packing and sealing values).
3 - Place the bag inside the chamber and close the chamber to start a work cycle.
4 - Check that the vacuum packaging percentage has reached 100%
5 -
Finish the cycle, open the chamber and extract the sealed vacuum packedproduct.
Start again from phase 3 for a new cycle.
Note: Every work step may be stopped by pressing the 1 button
Pressing the 1 button once = stop the vacuum packing and start the sealing cycle
Pressing the 1 button twice = cancel the cycle without sealing
4B.1.2 External Vacuum Packing Cycle
Place the switch (right side of the machine) Ref. 8 fig. 4B.1.2 in the ON position
The display will read OFF
Press the 1 button and put the machine in the ON mode (vacuum packing chamber).
Simultaneously press buttons 2 and 3 for 1 sec.
The display will show the message EXT. VACUUM
Check that the set time is sufficient.
If necessary, increase or decrease the time with keys 2 and 3.
Insert the tube for external suction (optional) in the suction hole, being careful to
remove the adjustable cap.
Press the 1 button to start the cycle.
The cycle will stop automatically when it reaches the set time.
Please note: Pressing buttons 2 and 3 at the same time will return it to the vacuum
chamber packing mode.
