Manual

25
4.5 - Cleaning the machine
ATTENTION!
Disconnect the machine from the mains electricity before cleaning.
Do not clean the machine using a jet of water.
Use non-toxic detergents only, expressly intended for clearing components coming
into contact with foodstuffs. DO NOT use chlorine-based detergents.
DO NOT use ethyl alcohol to clean the Plexiglas dome.
The Plexiglas must be cleaned regularly with a soft, damp cloth, using cold or
warm water, with a small amount of neutral detergent.
It is recommended to avoid:
- the use of products containing: denatured ethyl alcohol, solvents in general,
Benzene, Trichloroethylene
- the use of abrasive materials and contact with sharp objects
Drying
When the dome has been cleaned, it can be dried using a slightly damp chamois
cloth, without rubbing hard.
4.6 - Machine at rest
ATTENTION!
If the machine is not used for a long period of time, to prevent dirt and dust
depositing inside the chamber, close and fix the dome using the relevant fixing
knob.
4.7 - Vacuum pump heating
During the winter period, in the morning it is recommended to briefly pre-heat the
pump in order to fluidify the oil before it goes into circulation:
- Position the master switch (ref. 4 fig. 2.1.1) at ON.
- Close the suction cock (ref. 8 fig 2.1.1)
- Press the SAVE key 4 times (ref. 6 fig 4.1.1)
The machine will perform an oil heating cycle and the cycle will block automatically
on reaching a temperature of 50 °C.
If the operator wants to interrupt the cycle before it ends, he must press the switch-
on key ref. 1 fig 4.1.1.
N.B. This operation must only be performed with the intake cock closed.