Manual

21
The main food gas suppliers are:
Addresses can normally found in the telephone directory under the GAS heading.
The following table shows some product types with relative pre-determined mixture.
"We recommend the use of a gas pressure adjustment manometer with scale
from 0 to 6 Bar to guarantee gas inlet pressure into the machine of 0.4 - 0.5
Bar, as it is much more accurate than a manometer with scale from 0 to 30
Bar. If the gas inlet pressure should not be that indicated, the machine could
have problems in the working phase"
4.2.5 - Packaging with the use of the thermal printer
If the thermal printer has been activated in the machine, as described in paragraph
4.1.3, a label containing the following data will be printed at every vacuum cycle:
By briefly pressing the SAVE key (ref. 6 fig. 4.1.1) it is possible to have several
copies of the last label printed.
Fig. 4.2.3
SIAD SIO SAPIO RIVOIRA
PERGINE LINDE GAS SOL
SEALING TIME MATERIAL THICKNESS (micro)
2 CRYOVAC / HEAT-SHRINKABLE -
3 BAGS 100
4 / 5 BAGS 140
4.2.6 - Edit label printing
You can change the text "Vacuum packaging" on the label by adding a text up to
16 characters
With the machine powered (the main switch ref. 8 fig. 4.1.2 in ON) and the board OFF
Press and hold the key (1 fig. 4.1.1) for at least 5 seconds.
Press the key (5 fig. 4.1.1) and select "change printer".
Press the and keys (3 and 4 fig. 4.1.1) to select the character and confirm
it by pressing the key (6 fig. 4.1.1).
It will then go on to the next character until the desired text has been written
Confirm the new text by pressing the key (5 fig. 4.1.1)
Press the key (1 fig. 4.1.1) or wait 30 seconds to return to the OFF mode.
SAVE