Specifications

Secuthig th Eoi & nstaLiç tiC

Place the bowl on the bowl support (Fig.1 1171). The pin at the rear of the bowl must align with

the corresponding slot on the bowl support. Align the holes in the bowl mounting brackets

over the pins on the bowl support and lower the bowl into position.

With the bowl in the "down" position, install the desired agitator by sliding it upward onto the

beater shaft (Fig.1 [1]). Rotate the agitator counter-clockwise until it is engaged.

Safety Note Serious injury may result if the bowl is not positioned properly on the bowl support

using the bowl support pins.

With the bowl secured, add ingredients. Liquids should be added first. The bowl is now ready to

be raised to the "up" (mixing) position by turning the bowl lift handle (Fig.1 [14]) clockwise.

Secure and close the Swing RingTM Safety Guard before proceeding.

shig th Bow Lift

The mixer will not operate unless the bowl is in the "up" position. Raise the bowl by turning the

bowl lift handle (Fig. i [14]) clockwise. To lower the bowl, turn the handle counter-clockwise. It is

necessary to lower the bowl to change the agitator. This also makes the bowl accessible for filling.

Start/Stop Contr&s

The mixer will only start when the Swing RingTM Safety Guard is engaged and the bowl is in

the raised position. To start mixing, push the green start button. For safety and operational

ease, this mixer is equipped with a stop button (Fig.1 [131) that has an oversized, red mushroom-

style cap.

Safety Note Although the motor shuts off instantly when the Swing RingTM Safety Guard is

opened, or the bowl is lowered, or the stop button is pushed, the agitator may not come to

complete rest for several revolutions. Do not put hands or utensils into the bowl or near

the beater shaft until it is fully stopped.

Both the start button and stop button are momentary contact type. They provide low voltage

protection and prevent accidental start-up in the event of a power interruption.

PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor