Specifications

Ì\jç-l-c. '-: 7CL1Ì

I L

To install the Swing RingTM Safety Guard, insert the pointed end of the rod at the rear of the

guard into the lower mounting bracket on the mixer housing. Then insert the top end of the rod

into the upper bracket by aligning the groove in the rod with the slot in the bracket. Press the rod

in and allow it to drop down into position. Repeat this for each of the two sections of the guard.

Swing the two halves of the guard forward. When the guard is properly closed, the top of the

guard will engage magnets embedded in the transmission housing just above, The switches are

now activated and the mixer can be operated.

To remove the guard, simply reverse the installation procedure. Grip the two halves of the

guard and pull it open. Use an upward motion to release each half of the guard from the

bracket on the machine body.

To open the guard for access to the bowl, first turn the mixer off by pushing the red stop

button (Fig.1 [13]). Pull open the two halves of the guard and swing one or both outward. It

is not necessary to remove them, Close the guard to resume mixing operations.

Your Univex Mixer is designed to meet the Cook's and Baker's demand for an efficient, depend-

able appliance. It should give unfailing performance over a period of years when operated and

maintained according to the instructions contained herein and in the accompanying Mechanic's

Maintenance booklet.

The mixer drives various agitator attachments through a beater head shaft to beat, mix, or

whip liquid, viscous, or dry ingredients. The shaft is driven by a sturdy motor whose power

is transmitted by a rugged, cogged belt and a Continuously Variable Transmission (CVT)

through a gear train and a planetary gear set. The speed of the beater shaft can be varied

from approximately 90 to 365 revolutions per minute (rpm). (See page 13 for part numbers

of various agitators, attachments and accessories.)

The SRM2O Mixer is frequently equipped with a power take-off (PTO) that operates other

attachments, such as slicers, graters and grinders. The PTO speed can be varied from 60 to 240

rpm. Be sure to read and follow any safety instructions provided by the manufacturers of

attachments that you operate on the PTO. The PTO hub should be covered with the PTO cap

provided with your mixer when not in use.

WarningNever put hands, spoons, utensils or other objects into the bowl while the mixer

is operating!

PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor