Specifications

ï Mixer w
not operate
2 Mixer runs
but agitator
wll not turn
3 Agtator staUs
during mxng
5 Mixer runs, but
repeatecily stops
6 Attachments
contact bottom
of bow'
7 Attachments
contact side
of bow
8 Excessive noise
9 DifficuRy in
raising or
lowering bow
Timer not turned on (if provided)
Burned switch contacts
Electrical service down
Motor capacitor defective (1PH only)
Burned out motor
Magnetic starter tripped due to overload
Safety guard not mounted and closed
Bowl not raised
Slipping or broken belt
Key or pin sheared on input shaft, input gear,
bevel pinion, vertical shaft or beater shaft
Shifting speed with mixer not running
Mixer bowl is overloaded
Speed is settoo high for the mix
Loose belt
Contamination of belt with grease
Bowl overloaded
Speed is set too high for the mix
Service voltage too low or fluctuating
electrical supply
Dented bowl
Bowl height is set too high
Dented bowl
Insufficient clearance between bottom
of bowl and beater
Gears need to be repacked with grease
Badly worn or frayed drive belt
Attachments hitting bowl
Overloading of mixing bowl
Lack of lubrication on bowl lift slide
assembly and housing
Note: Remedies designated with a
require the
services of an authorized Llnivex service agent.
Turn timer on
Clean or replace contacts*
Check electrical service. Replace frise
or reset circuit breaker if necessary
Replace*
Remove, test, repair or replace*
Wait several minutes and push start button
Install safety guard
Raise bowl completely
Tighten or replace bel(
Locate by step inspection and replace
defective parts*
With mixer running, slowly move shift lever
frilly forward then backward to re-engage belt
Adjust contents of bowl per Mixing
Capacities Table
Shift speed lower till action rotates smoothly
Readjust pulley center distance to
tighten belt*
Clean pulleys and replace belt*
Adjust contents of bowl per Mixing
Capacities Table
Reduce speed
Check electrical voltage*. Reset
circuit breaker
Remove dents or replace bowl
Reset bowl height*
Remove dents or replace bowl
Adjust bowl height*
Locate source of noise by inspection and
repack with grease*
Replace belt*
Inspect for cause in items 6 & 7 above,
Adjust contents of bowl per Mixing
Capacities Table
Lubricate per Mechanic's Maintenance
guidehnes*
4 Speeds do not
Loose belt
Tighten or replace*
change propeily
Van-Speed pulley inoperative
Remove, clean & lubricate, or replace*
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor