Specifications

Consistent use of the following procedures will help ensure that your mixer is in
optimum condition.
WarningDisconnect electric power supply before cleaning.
Wash the body of the mixer, the bowl support, and beater shaft with warm water and
mild soap.
Avoid excess water in the area of the safety switches that protrude from the housing where
the Swing RingTM Safety Guard is mounted.
Do not rinse with a hose.
Do not use abrasive pads.
Dry the mixer thoroughly using a soft cloth.
Wash the bowl and beater immediately after use. If egg mixtures or flour batters have been
used, rinse the bowl and beater with cold water before washing with hot water. Wash the
Swing RingTM Safety Guard in the same manner, or in your dishwasher.
Dry bowls, agitators and safety guard thoroughly.
In
o s .e
The power take-off hub (Fig. i [5]) accommodates #1 2 tapered attachments, such as a Vegetable
Slicer and Shredder, or a Meat and Food Chopper. The mixer's speed control lever also controls the
PTO drive speed.
Before installing attachments, turn the mixer off. Remove the PTO cap and loosen the thumb
screw (Fig.1 [61) on the PTO hub, Insert the attachment with a slight twist until firmly in
place. Tighten the thumb screw. Be sure to read and follow any safety instructions provided
for attachments that you operate on the PTO.
Safety
Notes
When grinding meat, chopper attachments must never run faster than speed i
. For vegeta-
bles, attachments may run at higher speeds.
Always turn the mixer off to install or remove attachments.
Always return to speed i before shutting off mixer.
Cover the PTO hub with the PTO cap when not in use.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor