Specifications

SRM6O+/SRMSO+
If the mixer has been shut off by the timer, or stop button in speed 2, 3 or 4, follow these steps to
avoid belt slippage orjerky start: Empty the bowl. Set the timer to "HOLD". Press the start button.
As the mixer begins to operate, move the speed control lever back to speed i Press the stop button.
Return to "O". Your mixer is now ready for ìts next task.
Using the Ingredients Chute
The ingredients chute provided with your mixer enables you to add ingredients to the bowl while the
mixer is running, and without opening or removing the Swing RingTM Safety Guard. The chute may be
installed on the front or side ofeither halfofthe guard. See below. Once the chute is properly installed,
it can remain in place permanently, if desired.
Ingredients Chute Installation
Slide the bottom ofthe chute between horizontal safety guard rings and engage
the chute onto the safety guard.
Bowl Doffies & Adapter
Dollies (Page 10 & i i [h]), simpliÍj moving large, heavy batches to the next location. To use 40 for SO
bowl or 30 for 60 bowl withthe dolly, you must use a bowl adapter (Page 10 & 11 [i)). To remove
heavy batches from the mixer, first place the dolly underthe bowl. Then open the bowl clamps and
lower the bowl to the dolly. Be sure the bowl support pins clear the bowl mounting brackets before
moving the bowl and dolly.
Using Smaller Bowl
For maximum flexibility, an alternative 30 for 60 quart bowl is available for use on your SRM6O+
Mixer, and a 40 for SO and 60 for 80 for use on your SRM8O+ Mixer. Specially sized agitators must be
used. See page lO & i i for part numbers.
Splash/Extension Ring
A splash/extension ring (page 10 & 11 [j]) mounted to the bowl helps confme ingredients during the
mixing ofcertain recipes. The ring should never be used to overload a mìxer beyond its recommended
capacity. Consultthe Table ofMixing Capacities on page 8 & 9 when you are unsure of appropriate
loads.
USING THE POWER TAKE-OFF (PTO)
The power take-offhub (Fig. 1[5}) accommodates #12 tapered attachments such
as a Vegetable Slicer
and Shredder, or a Meat and Food Chopper. The mixer's speed control lever also controls the PTO drive
speed.
Before installing attachments, turn the mixer off. Remove the PTO cap and loosen the thumb screw (Fig.
i [6]) on the PTO hub. Insertthe attachment with a slighttwist until firmly in place. Tighten the thumb
screw. Be sure to read and follow any safety instructions provided for attaclunents that you
operate on the PTO.
Page 6
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor