Specifications

SRM6O+/SRM8O+
Using the Bowl Lift
The mixer will not operate unless the bowl is inthe "up " position. Raise the bowl by tuming the bowl
lift handle (Fig. i [13]) clockwise. To lowerthe bowl, turnthe handle counterclockwise.
Ifyour mixer is equipped with the power bowilift option(instead ofthe handle)turn the power bowl
lift
switch clockwise to raise the bowl, counter-clockwise to lower the bowl,
It is necessary to lower the bowl to change the agitator. This also makes the
bowl accessible for filling
Setting the Tinier - Start/Stop Controls
This mixer will not operate unless the timer has been set to a specified number ofminutes or set
in the
"HOLD" position. To startthe mixer, firsiturn the timer dial (Fig. i [81)to the desired
mixing time.
Then push the start button(Fig. i [11]). The mixer will automatically stop when the timer reaches "O".
To stop mixing before the timer reaches "O", pushthe red stop button(Fig. i [12]).
The timer may be set for up to 15 minutes ofmixing, or may be set to the "HOLD"
position for
continuous operation. When setting a time ofless then 5 minutes, turn the dial beyond 5 minutes
and
then return itto the desired time.
Safety Note The mìxer will start only when the Swing RingTMSafety Guard is engaged
andthe bowl is
in the raised position. Do not operate the mixer without the bowl in place.
Manual Stop Button
For safety and operational ease, this mixer is equipped with a stop button (Fig.1
[12])that has an
oversized, red mushroom-style cap.
Safety Note Although the motor shuts offinstantly when the Swing RingTM Safety Guard is
opened, or
the bowl is lowered, or the stop button is pushed, the agitator may not come to complete rest
for several
revolutions. Do not put hands or utensils into bowl or near the beater shaft until it Is
stopped.
Both the start button and stop button are momentary contact type. They provide low
voltage protection
and prevent accidental start-up in the event ofpower interruption.
Vail-Speed Control
A major advantage ofUnivex mixers is their Continuously Variable Transmission
(CVT). Unlike other
mixers, CVT lets you change speed while the mixer Is running. Change speed by
movingthe speed
control lever (Fig. 1 [9])to the desiredlevel. The speed indicator (Fig. 1 [10]) shows
four speeds.
Numerous intermediate speeds give the Cook or Backer tremendous flexibility.
Use speed 1 (slow) for heavy mixtures like pizza, bread or roll dough. Speed 1
should also be used with
the Meat and Food Chopper attachment For most mixingtasks, start on speed 1
and progress to higher
speeds as needed. Use high speeds for wipping cream, beating eggs, andthin batter. To
avoid damaging
your mixer, follow the speed, volume limits and attachments
recommendations shown in the
Table ofMixing Capacities on page 8 & 9.
Ifyou notice any slippage during mixing, the mixer may be overloaded. Reduce the load, or
reduce
speed until mixing action is smooth. Referto the Trouble- ShootIng Guide on page 14 & 15.
Ifthe mixerjanis and the motor stalls, immediately press the stop button. Take necessary steps
to reduce
the load. Never put hands in the bowl to clear siam.
Note Always return to speed i before shutting off the mixer. Do not move the
speed control lever
when the mixer is not running, because this will cause belt to become loose and the mixer
will not
operate properly.
Page 5
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor