Specifications

SRM6O+/SRM8O+
down into position. Repeat this for each ofthe two sections ofthe guard. Swing the two halves of the
guard forward. When the guard is properly closed, the switches are now activated and the mixer can be
operated.
To remove the guard, simply reverse the installation procedure. Grip the two halves ofthe guard and
pull it open. Use an upward motion to release each halfofthe guard from the bracket on the machine
body.
To open the guard for access to the bow1 first turn the mixer off by pushing the red stop button
(Fig. i [1 2]). Pull open the two halves ofthe guard and swing one or both outward, It is not necessary to
remove them. Close the guard to resume mixing operations.
OPERATING THE SRM3O+ MIXER
Your Univex Mixer is designed to meet the cook's and Baker's demand for an efficient, dependable
appliance. It should give unfailing performance over a period ofyears when operated and maintained
according to the instructions contained herein.
The mixer drives various agitator attachments through a beater head shalt to beat, mix,
or whip liquid,
viscous, or dry ingredients. The shaft is driven by a sturdy motor
whose
power is transmitted by a
rugged, cogged belt and a Continuously Variable Transmission (CVT)through a geartrain and
a
planetary gear set. The speed ofthe beater shaft can be varied from approximately 60 to 270 revolution
per minute (rpm)for SRMSO+ and 75 tO 340rpm for SRM6O+. (See page IO & i i for part numbers of
various agitators, attachments and accessories.)
The SRM6O+/SRM8O+ Mixer is equipped with a power take-off(PTO)that operates other attachments
such as slicers, graters and grinders. The PTO speed can be varied from 85 to
385
rpmfor SRMSO+ and
SRM6O+. Be sure to read and follow any safety Instructions provided by the manufacturers of
attachments that you operate on the PTO. The PTO hub should be covered with the PTO cap
provided with your mixer when in use.
Warning--Never put hands, spoons, utensils or other objects into the bowl while the mIxer is
operating!
Note: Noise emissions are below 70db (A).
Securing the Bowl & Installing the Mixer Agitator.
Place the bowl on the bowl support (Fig. i [15]). The indentation on the rim ofthe bowl must align with
the corresponding pin on the mixer housing. Align the holes on eighter side ofthe bowl rim
over the pins
on the bowl support andlower the bowl into position. Secure the bowl by turning the bowl clamps (Fig.
i [16]).
With the bowl in the "down" position, installthe desired agitator by sliding it upward onto the beater
shaft (Fig. 1 [1]). Rotate the agitator counter-clockwise until it is engaged.
Safety Note Serious injusy may result ifthe bowl is not fully secured to the bowl support using the bowl
support pins and firmly closingthe clamps.
With the bowl secured, add ingredients. Liquids should be added first. The bowl is
now readyto be
raised to the "up"(mixing)position byturningthe bowl lifthandle (Fig. 1[131) clockwise.
When using the wire whip agitator, raise the bowito the "up" position first and then add ingredients
to
avoid wire whip damage.
Secure and close the Swing
PgTM Safety Guard before proceeding.
Page 4
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor