Specifications

SRM6O+/SRMSO+
CHOOSING THE RIGHT LOCATION FOR YOUR NEW MIXER
When selecting the best location for the mixer, it is helpful to consider the following:
.
Where is the best location for the operator, both for saving steps and easy
viewing?
s
Is this a good location for product flow as in:
*
Easyto get ingredients to the mixer?
s
Destination ofthe mix alter mixing?
.
Is there existing electrical service at this location?
.
Does this location provide easy access for cleaning and service?
.
Check to be sure that your mixer with attachments does not extend out
into heavy traffic areas.
.
Ifstands and/or portable equipment are used along side ofyour mixer,
can they be moved easily to and from your mixer?
.
Ifunit is not provided with a plug, then the unit is to be fitted with a primary disconnect
device that has a contact separation of at least 3mm in all poles.
IMPORTANT ELECTRICAL SERVICE INFORMATION
Electrical wiring instructions are found in the wiring diagram (Figures l2Athru 12C). Before making
electrical connections, CHECK the specifications on the nameplate to make sure that they agree with
those on your electric service.
USER-FRIENDLY SWING RINGTMSAFETY GUARD
Your SRM6O+/SRMSO+ Mixer features a newly updated, 2-part safety guard. The Swing RingTM
Safety Guard ring is easily be removed and installed, as well as dishwasher safe. It conveniently swings
out ofthe way without having to be removed to place or sample ingredients in the bowl. Only one side
ofthe guard needs to be open when adding ingredients. You'llfindthis twopiece design is easy to
handle and fits conveniently in your sink or dishwasher. It also provides a clear view ofthe product
throughoutthe mixing cycle.
This mixerwifi not operate unless the Swing Ring1M Safety Guard Is properly engaged.
Metal tabs atthe rear ofthe guard activate twin switches that enable the mixer to run only when the
guard is securely closed. These switches protect against accidental operation ofthe mixer when the
safety guard is open or removed from the mixer. The mixer wìll automatically stop ifthe guard is open.
Additional switches in the bowl slide mechanism automatically stop the mixer ifthe bowl is lowered
from the "up" (mixing) position.
To Install the Swing Ring
Safety Guard, insert the pointed end ofthe rod at the rear ofthe guard into
the lower mounting bracket on the mixer housing. Then insert the top end ofthe rod into the upper
bracket by aligning the groove in the rod with the slot inthe bracket Press the rod in and allow it to drop
Page 3
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor