Specifications

Page 24
SRM6O+/SRM8O+
SPEED CONTROL (Fig. 8)
i
Run mixer and shift to first speed then turn mixer off.
Warning: For safety disconnect electrical supply.
Remove rear access panel (Fig. 10 [22)) and top cover (Fig. 10 [17])
instructions on page 4.
Remove drive belt per instructions 1 in mechanics maintenance.
Warning: Handle (Fig. 8 [25]) has spring loaded rotation. Hold handle to
prevent injury.
While holding handle (Fig. 8 [25]) remove set screws [20] and rotate
handle counter clockwise two full turns. This disengages the spring [1 11.
Note: The ball [3] and spring [4] may fall out of block [6].
Loosen set screws (Fig. 8 [1), drive roll pin [22] from hub [23] and pull
hub from shaft [10]. Unscrew hub [23] and handle [25] from lever [24].
Slide retaining rings [9], cam [8] and spring [1 1] towards locating block
[6]. Remove key [19] from shaft, loosen nuts [12] securing detent housing
[11
Drive shaft [10] inward until it contacts the left sìde housing wall. Pull
detent housing [1] and shaft assembly [10] towards rear of machine and
remove assembly from mounted bearing [18].
Slide spring [1 1] retaining ring [9], cam [8] and belleville washer [2] from
shaft [10]. Drive roll pin [7] from block [6].
Slide block [6] from shaft
[10].
Remove nuts [12], washers [13 & 14] and bracket [15] from housing.
Remove bolts [16 & 17] securing bearing [18] to bracket [15].
Reassemble in reverse order of above
Adjust assembly as described in Mechanics Maintenance 1 d, & e.
If speed handle creeps during operation tighten the two set screws (Fig. 8 [5]) which
push against the belleville washer [2] until creeping stops.
HOUSING (Fig 10)
For the remaining parts which have not been discussed pertain to electrical
components, and the housing, Figures 10, 12A, l2B, and 12C should provide
adequate guidance for the disassembling and reassembling oftbese parts.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor