Specifications

ç
SRM6O+/SRM8O
Secure slide (Fig. 7 {34}) in frame [1) by bolting gibbs [29] to frame with
four hex head cap screws [15]. Check to insure that slide moves freely in
frame. If not, remove gibbs and shim where needed.
Screw lead screw [10] into floating nut [28] and push slide to bottom of
frame so that the lead screw does not protrude through hole in frame.
Place the collar [3] and then thrust washer [4] over top of lead screw [10].
Push slide and lead screw up so that the lead screw protrudes through hole
in frame.
Place thrust washer [4} and then miter gear [12] on top of lead screw [10].
Drive roll pin [11] through miter gear [12] and into lead screw [10].
Push slide & lead screw down as far as possible. Slide collar [3] and thrust
washer [4] up against frame and tighten set screws [2] in collar against
corresponding flats on lead screw [10].
Check DU bearings in yoke for burrs (Fig. 7 [6]). Install yoke [7] to frame
[1] (do not tighten bolts).
Lift assembly into mixer housing. Place assembly on S weld studs.
Tighten assembly to mixer housing using washers and Kep nuts.
Insert bowl lift lever assembly (Fig. 7 [35-38,40,41]) through hole in mixer
housing. Slide collar [3] and thrust washer [42] over end of lever. Insert
lever through yoke while holding the thrust washer
[41
and miter gear [9] in
position. Continue to slide lever through until miter gear seats against
shoulder on the lever shaft. Align key ways of miter gear and lever, insert
key [39]. Tighten set screw [8]. Squeezing miter gear [9] and collar [42],
tighten set screw [2].
li.
With yoke bolts [15] lightly tightened, tap yoke back and forth until the
miter gears mesh smoothly. Tighten bolts [15]. Adjust hub [40] so that it
is positioned 1/32" from mixer housing. Tighten set screw [41].
Lubricate the miter gears and lead screw with general purpose machine
grease.
Raise and lower bowl lift by turning the bowl lift lever [37]. The
mechanism should turn freely.
Raise bowl all the way. Check clearance between bottom of bowl and
batter beater attachment. The clearance should be 3/16 ± 1/16. If the
clearance is not sufficient, adjust bowl stop (Fig. 7 [25]). Loosen jam nut
[26}, raise or lower bowl stop as needed and tighten jam nut.
Make sure bowl lift safety switch (Fig. 7 [19]) is actuated by the retainer
plate [24] when the bowl is raised completely. Ifthe switch is not actuated,
or the lever on the switch is being bent, adjust the bracket [17] by
loosening screws [23] and raising or lowering until the switch actuates.
Note: The bowl should continue to raise 1/8' after switch actuates.
Page 23
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor