Specifications

SRM6O+/SRM8O+
Remove the top 4 Kep nuts (Fig. i i [14]) that secure motor assembly to
mixer base.
Remove motor electrical leads (Fig. i i [13}) from magnetic starter (Fig. 10
[26]). Remove motor ground lead from stud.
C.
Lift motor assembly from mixer housing.
CAUTION: Drive assembly can weight in excess of 100 lb. depending on
type ofmotor. Use mechanical lift assistance.
Remove bowl from bowl support.
Remove two screws (Fig. 9 [121).
Remove 4 screws (Fig. 7 [321).
CAUTION: Someone should be holdìng bowl support (Fig. 9 [1}) while
the screws are being removed, so that it does not fall and get damaged.
Remove slide cover (Fig. 9 [10J).
Loosen set screws (Fig. 7 [2)) and Fìg. 7 [8]).
Withdraw handle assy. (Fig. 7 [38]) from the outside ofmixer housing.
Collect gear [9], key
[391,
washers [4 & 42] and collar [3].
Remove 8 nuts (Fig. 7 [3 1]) and pull slide/frame assembly from studs and
remove from mixer housing.
CAUTION: Assembly is heavy.
Remove 2 hex head cap screws (Fig. 7 [15]). This allows for removal of
yoke (Fig. 7 [7]).
i 1.
Drive roll pin (Fig. 7 [1 1)) from miter gear (Fig. 7 [12]). Remove miter
gear and thrust washer (Fig. 7 [4]) from lead screw (Fig. 7 [10]).
Press lead screw (Fig. 7 [10]) through hole in frame [1].
Loosen set screws (2). Remove collar [3] and thrust washer (Fig. 7 [4]) by
pulling them from lead screw.
Unscrew lead screw from floating nut (Fig. 7 [28]) and remove.
Remove 4 screws (Fig. 7 [27]) and remove gibbs (Fig. 7 [29)). The slide
may now be removed from the frame.
NOTE: Save any shim strips that may have been used between the frame
and the gibbs.
It is recommended that the location be marked at this time
with a pencil to facilitate reinstallation.
BOWL LIFT & SLIDE. REASSEMBLY & INSTALLATION (Fig. 7)
Grease sliding surfaces of slide & frame. See Lubrication page 18.
Keeping shims in place (if any), position slide in frame as shown in Fig. 7.
Page 22
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor