Specifications

©
Oil Level n
Housing fo be
6 from Top
of Housin9.
Internal Gear
Beater Shaft
Bowl Lift
Slide and
Lead Screw
SRM6O+/SR8O+
d.
If adjustment is required, loose jam nut (Fig. 7 [26]) and turn threaded
bowl
stop rod (Fig. 7 [25}) until the desired clearance is obtained, then tighten
the
jam nut.
DRIVE BELT REPLACEMENT (See CVT Belt Drive)
LUBRICATION
WARNING: FOR SAFETY, DISCONNECT ELECTRICAL POWER TO
THE
MIXER.
a.
The lubrication instructions are listed in Figure 2.
b,
Remove access panel (Fig. 10 [22]), top cover (Fig. 10 [17])
per page 4.
In order to service the gearbox, it will be necessary to flirther
remove the
gearbox cover (Fig. 3 [2]). A thin blade putty knife will
prove helpful in
separating the silicone sealant between this cover and the gearbox. Do
not
bend cover. Thoroughly remove all dried sealant before applying
new sealant
when reinstalling the cover. Do not allow dried sealant to enter gearbox.
Silicone rubber sealant such as Dow Corning Silastic 732RTV
or Permatex
Form-A-Gasket are recommended.
WARNING: NEVER WORK ON THE GEARBOX WITH THE MIXER
RUNNING.
Use care to avoid getting lubricant of any kind on the drive belt and pulleys
as
this would seriously deteriorate the belt grip and mixer performance.
LUBRICATION INSTRUCTIONS
FIGURE 2
Bowl Clamp
-. TTi!It Vj
Page 18
® GREASE EVERY 6 MO.
GENERAL PURPOSE
MACHINE GREASE.
® REPACK GREASE EVERY 500
HOURS OF OPERATION
ON PLANETARY GEARS.
USE KEYSTONE
NEVASTANE 5P7.
® 140 WT GEAR OIL
AFTER EVERY WASH APPLY
LIGHT COAT OF FOOD-GRADE
LUBRICANT SUCH AS. PETROGEL.
208-240V. 50HZ. I & 3PH AC,
Motors. Lubricate every ten years
with hiqh quality ball beans9 grease
oppliedinto the two Alemite fittings.
with ose or two full strokes.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor