Specifications

SRM6O+/SRM8O+
SRM6O+/SRM8O+ TROUBLESHOOTING GUIDE
(CONT'D).
* Remedies designated with
a
require the services of an authorized service agent.
Page 15
'
5. Mixer runs, but
repeatedly cuts
out and stops
f
s. i
Bowl overloaded
5.2 Speed is set too high for
the mix
5.3 Service voltage too low or
fluctuating
5.4 Starter improperly set
5. 1 Adjust contents of bowl
per Mixing Capacities
Table
5.2 Reduce speed
5.3 Check electrical voltage. *
5.4 Adjust amp setting on
starter.
6. Attachments
contact bottom
of bowl.
6.1 Dented bowl.
6.2 Bowl height is set too high
6.1 Remove dent or replace
bowl.
6.2 Reset bowl height. *
7. Attachments
contact side of
bowl
7.1 Dented bowl
7.2 Insufficient clearance
between bottom of bowl and
beater.
7. 1 Remove dents or replace bowl
7.2 Adjust bowl height. *
8. Excessive
noise.
8.1 Gears need to be repacked
with grease, or oil level is
low.
8.2 Badly worn or frayed drive
belt.
8.3 Attachments hitting bowl
8.4 Overloaded mixing bowl
8.1 Locate source by
inspection and repack
with grease, or top off oil
level. *
8.2 Replace belt.
8.3 Inspect for cause in items
6 and 7 above.
8.4 Adjust contents of bowl
per Mixing Capacities
Table
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor