Specifications

SRM6O+/SRM8O+
SRM6O+/SRMSO+ TROUBLESHOOTING GUIDE
Page 14
TROUBLE
POSSIBLE CAUSE
REMEDY
1 , Mixer will not
operate.
1 . i Timer not turned on.
1.2 Burned switch contacts
1.3 Electrical service down.
1,4 Motor capacitor defective.
(1 PH Only)
1.5 Burned out motor.
1.6 Magnetic starter tripped
due to overload
1.7 SAFETY RING not
mounted and closed.
1.8 Bowl not raised.
1 . 1 Turn timer on.
1.2 Clean or replace contacts.
1.3 Check electrical service.
Replace fuse or reset
circuit breaker if necessary.
1.4 Replace. *
1.5 Remove, test, repair or
replace. *
1.6 Wait several minutes and
push start button
1.7 Install SAFETY RING.
1.8 Raise bowl comnletelv
2. Mixer runs but
agitator will not
turn.
2. 1 Drive belt off pulley
2.2 Key or Pin sheared on input
shaft, input gear, bevel
pinion, bevel gear, vertical
shaft or beater shaft.
2.3 Shifting speed with mixer
not running.
2.1 Reinstall drive belt on
motor pulley and adjust
mount center distance. *
2.2 Locate by step inspection
and replace defective part.*
2.3 With mixer running, slowly
move speed control lever
slowly fully forward then
backward to re-engage belt
3. Agitator stalls
during mixing
3.1 Mixer bowl is overloaded
3.2 Speed is settoo high forthe mix
3.3 Loose belt
3.4 Contamination ofbelt with
grease
3. 1 Adjust contents ofbowl per
Mixing Capacities Table
3.2 Shift speedlower till action
rotates smoothly
3.3 Readjust pulley center distance
to tighten belt.
'
3.4 Clean pulleys and replace belt *
4. Speeds do not
change properly
4.1 Loose belt.
4.2 Van-Speed pulley
inoperative
4.1 Tighten or replace belt. *
4.2 Remove, clean & lubricate,
or replace. '
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor