Manual

4
2.0) IDENTIFICATION. A plate similar to the one below identifies the machine; it shows
the machine model types, serial numbers, and the electrical operating characteristics.
FIGURE 2
IDENTIFICATION PLATE
MODEL SERIAL NUMBER
VOLTAGE FREQ Hz PHASE Kw
3 OLD ROCKINGHAM RD
SALEM, NH O3079
1-800-258-6358
3.0) OPERATING ENVIROMENT
Local conditions: The machine should be installed in a lighted, airy building, on a
compact and level support. Temperature ranging from 5°C to 40°C (40
o
– 104
o
F);
humidity not over 50% at 20°C (68
o
F), or not over 90% at 40°C (104°F).
Lighting: Lighting available for the operator must comply with the type of work being
carried out.
Vibrations: When operations are properly executed, vibrations cannot provoke dangerous
situations.
Acoustic emissions: <75 dbA – normal use.
Electromagnetic environment: This machine has been conceived to operate in an
electromagnetic industrial environment.
4.0) MACHINE CONTROLS
1) Master circuit breaker with mains
signal lamp.
2) Control lever and motion reverse.
(upon request)
3) Control pedal and motion reverse.
4) Adjusting lever for fining down.
5) Trigger for lever 4
6) Ratchet of lever 4
7) Protection grid
FIGURE 3
CONTROLS