Manual

Pagina 10

The machine must only be installed by qualiﬁed and authorised staff.

The machine must only be used for the purpose of dividing or dividing and rounding dough.

The warranty is not valid if changes are made without the manufacturer's authorisation and/or if non-original

spare parts are used. Use of non-original spare parts can damage the machine and/or harm the operator.

The machine must be positioned on a solid and regular ﬂoor. The machine is very stable.

6.1 POSITIONING AND MAINTENANCE

6.2 ELECTRICAL CONNECTION

A qualiﬁed technician should carry out installation and an electrician should connect the machine to the

power supply system. Firstly check the voltage and the connection phases are equal to those of the

machine (see identiﬁcation plate). If this is not the case, contact the retailer.

Check the rotation direction of the motor on the machine. Turn the main knob to position I-ON. Close the

guard casing and run an "empty" work cycle. Check if the shaping plate oscillates. If this is not the case, an

electrician must invert the phases, i.e. he must invert the two cables in the power plug to change the rotation

direction of the motor.

6.3 DISPOSAL OF THE MACHINE

When you want to dispose of an entire machine, parts or just the packaging, you must comply with the

waste disposal rules. Speciﬁcations regarding the material on the various parts can be obtained from the

manufacturer. See WEEE.

6.4 PLACING MACHINE OUT OF SERVICE

Switch off the machine by bringing the main switch to 0-OFF and subsequently protecting the machine from

external factors and leave it in a dry and enclosed location.

6 - INSTALLATION