Manual

ROTORBAKE Series Ovens - electric version - Page 43
Make sure that the steam display reads:
then save by pressing:
Perform the same steps for the remaining steam injections.
(If you wish to control a single steam injection, set the second and third injection time
parameters to 0 in the remaining steam injection cycles)
When the last parameter of the steam injection set point is saved, the entire program is
automatically saved as well.
PROGRAMMED BAKING
Make sure that the oven has been properly connected, then turn the main switch G and
turn on the computerized oven control by pressing the key:
Recall and save the desired baking program
Press the following keys consecutively:
The program number to call up is:
then save by pressing:



  

   

 


   