Manual

ROTORBAKE Series Ovens - electric version - Page 19
E LECTRICAL C ONNECTION
!
Caution!
Only qualified personnel may carry out the electrical connection. Strict observance
of CEI specifications and regulations is required.
Check the oven setup, comparing the type of mains current and voltage available with the
levels shown on the serial plate. The electrical diagram is included in this manual.
The equipment may be connected to the mains only if a disconnect switch is included, with
at least 3 mm of open space between the contacts for each pole. The switch must be
located in an easily accessible position and close to the oven.
The connection cables must be at least type H07 RN-F. The minimum size and number of
wires may be found in the “Electrical specifications” table. Fixed connections require the
use of regulation cable channels.
Remove the terminal board cover, insert the cable in the holder and connect each wire to
the corresponding terminal. The plate near the terminal board indicates the correct
positions of phases and neutral.
Once the cable is connected to the terminal board, tighten the cable holder on the back of
the equipment and close the cover.
Electrical safety may be guaranteed only when the equipment is efficiently grounded as set
forth in current regulations.
The oven must also be included in an efficient equipotent system.
This connection is made using the special terminal marked with the symbol , located at
the back of the equipment.
G – Equipotent terminal
H – Power cord inlet