MG8912 MEAT & FOOD GRINDER OPERATOR’S MANUAL Persons under age 18 are not permitted to operate or have accessibility to operate this equipment per U.S. Dept. Of Labor Employment Standards Administration Fact Sheet No. ESA913.
TABLE OF CONTENTS DESCRIPTION PAGE TABLE OF CONTENTS ...........................................................................................................1 LIST OF ILLUSTRATIONS .....................................................................................................1 INSPECTION ............................................................................................................................2 SAFETY ..............................................................................
MODEL MG8912 MEAT GRINDER INSTRUCTION MANUAL Welcome to Univex Thank you for purchasing this Univex Product. Your new MG8912 Meat Grinder has been designed with advanced performance and safety features that make it an excellent addition to your food preparation equipment. Like all Univex mixers, slicers, meat grinders and accessories, this meat grinder is engineered to provide years of reliable service.
SAFETY IS OUR TOP PRIORITY READ AND MAKE SURE THAT YOU UNDERSTAND THE INSTRUCTIONS AND SAFETY WARNINGS IN THIS BOOKLET BEFORE ATTEMPTING TO OPERATE THIS MEAT GRINDER. NEVER PUT FINGERS OR HANDS IN THE THROAT OF THE GRINDER WHILE THE GRINDER IS OPERATING OR SERIOUS INJURY WILL RESULT. NEVER ATTEMPT TO CLEAR JAMMED PRODUCT WITHOUT SHUTTING THE POWER OFF AND DISCONNECTING THE ELECTRICAL POWER SUPPLY CORD.
OVERALL VIEW OF MEAT GRINDER FIGURE 1 1. POWER UNIT 5. FEED PAN 2. POWER SWITCH 6. PAN SUPPORT 3. GRINDER HEAD 7. 4. STOMPER 8.
ASSEMBLY INSTRUCTIONS Attach the pan support (Figure 1 [6]) to the housing cover using two 10-32 pan head screws. The PTO adapter (Figure 2) should remain on the PTO drive shaft when the grinding head is removed. The components of the grinder assembly should be washed with a warm water and mild soap solution and dried prior to use. Inspect the knife (Figure 4 [6]) for sharpness and handle it with care. Remove the PTO cover cap. Insert the grinder housing (Figure 4 [4]) into the PTO hub of the drive unit.
POWER TAKE-OFF HUB (PTO) FIGURE 2 THUMB SCREW PTO HUB ALIGNMENT PIN LOCATING HOLE PTO ADAPTER COVER CAP WORM ASSEMBLY FIGURE 3 WORM FIBER WASHER DRIVE SHAFT APPLY PETROL-GEL TO THESE SURFACES PRIOR TO ASSEMBLY Page 6
OPERATING INSTRUCTIONS Choose a location for the MG8912 that is convenient for the operator, allowing free access to the power switch and sufficient clearance for safety and care of operation. Slice the meat into strips which will easily fit into the throat of the grinder. Place a suitable container at the discharge of the grinder. Place the meat in the feed pan and start the grinder. Hand feed the meat into the grinder.
GRINDER WITH PAN AND STOMPER FIGURE 4 ITEM No. 1 2 3 4 5 6 7 8 9 PART No. 1000735 8700011 4400351 1000651 1000653 1000506 1000509 1000508 1000510 1000511 1000512 1000652 4400408 DESCRIPTION Stomper Pan, Stainless Steel Label Housing Assembly Worm Assembly Knife Plate 3/16 Plate 1/8 (optional) Plate 1/4 (optional) Plate 3/8 (optional) Plate 1/2 (optional) Ring Petrol-Gel (not shown) Page 8 Qty.
Warranty The Univex MG8912 meat grinder carries a one-year, on-site parts and labor warranty against any defects in materials or workmanship. The one-year period begins on the date of purchase by the end user and remains in full effect provided the unit is used properly and in accordance with our instructions. Any work to be performed under this warranty must be performed between the hours of 8:00 am and 5:00 pm local time, Monday through Friday. Univex will not cover overtime charges of any kind.
