Instruction manual

ELECTRICAL ASSEMBLY
I. WARNING DISCONNECT ELECTRICAL SUPPLY
Remove four rubber feet (Fig. 2 [241) and 4 extonsion legs (Fig. 2 [52 J).
Remove bottom cover (Fig. 2 [19)).
Remove casing cover (fig. 8 [22)).
Distharge capacitors by jumping across terminals with electrically protected screwdriver.
Remove reduction gear rod (Fig. 2 [34)) by removing two bolts (Fig. 2 [38)) and removing set
screw at reduction gear md.
Remove switth shaft (Fig. 8 [16)) by loosming nut (Fig. 8 [iS)) near switth md.
Remove capacitor on left to access ground screw holding electrical equipmmt casing.
Remove electrical equipmmt casing by removing three screws (Fig. 8 [21)).
Replace capacitors (Fig. 8 [24)) if found to be defective.
il. Relay (Fig. 8 [7)) and switth (Fig. 8 [20)) can also be thecked from this procedure.
12. Replace any defective electrical componont and reverse procedures to reassemble.
Page 11
8512
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor