Instruction manual
6512
Never use detergents or wash the slicer or any of its parts in a dishwashing
machine or the clear protective finish will be damaged.
Warning
5.
Wash body of slicer using warm water and mild soap using a clean soft cloth.
Under no circumstances should the slicer be hose rinsed. It is recommended that
the cloth be folded over a thin wooden stick when cleaning between the fence and
the knife.
Remove knife guard (Figure 1 [3]) by loosening knife guard knob (Figure 3
[31]) and pushing the long stud upward to lift knife guard above surface of knife.
Then carefully lift and remove guard.
Remove Knife deflector (Fig 4 [9]) by unscrewing (Fig 4 [lO]).
Warning:
8.
CAREFULLY wash the front and rear of the knife with a cloth using warm
water and mild soap. It is recommended that the cloth be folded over a thin
wooden stick as a further caution to avoid accidental contact with the knife edge.
CAREFULLY wash between the knife edge and protective guard (Figure 1 [4])
using a soft cloth inserted between knife edge and guard on both front and rear of
knife using extreme caution to never touch the knife edge. Rinse with warm
water applied with a cloth. Dry thoroughly with a clean soft cloth.
Caution:
9.
Following cleaning, a commercial non-toxic sanitizer may be wiped on the clean
surfaces with a soft clean cloth or sprayed as recommended on the container
labeling. It is important that the sanitizer be compatible with anodized aluminum
or the clear protective finish on the slicer will be damaged. Surface should be
wetted completely, but not to the point of running or puddling.
Warning:
10.
Replace the knife guard. Never leave the slicer without its knife guard installed!
11.
Replace Knife deflector.
LUBRICATION & FUNCTION CHECK
Warning:
Turn off slicer and DISCONNECT ELECTRICAL CORD before lubricating. Leave
protective guard (Fig. 1 [4]) in place.
General lubrication should be performed in accordance with the lubrication instructions in Fig. 2.
During this lubrication sequence, be sure to check for free operation and movement of related parts
as well as for excessive wear and looseness of various parts. Be sure to check all handles and knobs
for tightness.
Page 6
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor