Instruction manual

6512
Install replacement belt on knife pulley and on motor pulley shaft. DO NOT reinstall
knife at this time.
Reinstall motor pivot bolt.
li.
Reinstall spring and nuts on motor adjustment rod (Figure 3 [26] ) and tighten. It is
important to make sure that the belt ìs aligned on both pulleys.
Belt tension is correct when the spring is compressed to an overall length of 7/8.
Connect electrìcal power cord and operate slicer to check that belt and pulley are
running true.
Turn off slicer and disconnect electrical power cord.
Reinstall bottom cover and secure with the four suction feet.
Reinstall belt guard with 7 screws.
Using caution, reinstall knife and secure with four screws.
Reinstall knife guard and secure with knife guard knob.
Reinstall sharpener and secure with knob assembly.
Page 12
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor