Instruction manual

6512
Reinstall pulley insert and shims that may have been present Apply liberal coating of
Petro-Gel to the seal/insert interface.
Reinstall knife, knife guard and sharpener in the reverse procedure outlined above.
SHARPENING STONES
I.
Warning: Disconnect electrical cord.
Unscrew sharpener knob assembly (Figure 5 [28] ).
Lift up sharpening assembly (Figure 1 [2] ) and remove from slicer.
Using an open end wrench, unscrew cover knob (Figure 5 [1]).
It is recommended that a
piece of tape or paper be temporarily wrapped around knob prior to unscrewing it so as to
protect its finish. Remove cover (Figure 5 [2]) off of mount assembly.
Unscrew nut (Figure 5 [191 ) and remove along with washer and sharpening stone
(Figure 5 [21] ).
Install new sharpening stone. Hollowed side should be toward the outside.
Honing (deburring) stone (Figure 5 [12] ) is removed by first unscrewing lock screw
(Figure 5 [17] ) from button (Figure 5 [16] ).
Gently remove button taking care to not lose the small ball bearing and spring (Figure 5
[14 & 15] ) which are inside.
Unscrew nut (Figure 5 [13] ) and remove along with washer and honing stone (Figure 5
[12]).
Install new honing stone with the hollowed side toward the inside.
Reattach cover and reinstall in the reverse procedures (4. through 1.).
DRIVE BELT REPLACEMENT
Warning: Disconnect electrical power cord.
Remove knife per knife replacement instructions.
Remove the 7 screws (Figure 3 [14]) and belt guard (Figure 3 [15]).
Remove four rubber suction feet (Figure 6 [13] ) that secure bottom cover (Figure 6 [12]
to slicer. Remove cover.
Remove nuts (Figure 3 [21] ) from motor adjustment rod (Figure 3 [26] ) so motor can
be pivoted to give belt slack. Be careful not to lose tensioning spring (Figure 3 [19]).
Remove motor pivot bolt (Figure 3 [28]).
Unwrap belt from motor pulley shaft.
Unwrap and remove drive belt from the knife pulley (Figure 3 [6]).
Page 11
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor