Instruction manual
REPAIR INSTRUCTIONS
Including disassembly, replacement, and reassembly.
Warning: Always turn off slicer and disconnect electrical cord before doing any maintenance or
repair on the slicer. Keep guards on at all times. Keep slice adjustment fishy closed so
knife edge is not exposed. Keep sharpener assembly also in place so top of knife edge is
not exposed.
KNIFE REPLACEMENT (FIgure 3)
Warning: Disconnect electrical power cord.
Remove carriage assembly (Figure 1 [8, 12})
Loosen sharpener knob assembly (Figure 5 [4] ), then lift and remove sharpening unit Set
aside.
Remove knife guard knob (Figure 3 [31] ) and carefully remove knife guard (Figure 3
[IO]).
Warning: Using caution to avoid the sharp knife edge, remove the four screws (Figure 3
[il]) that secure knife (Figure 3 [12] ).
Carefully remove knife and set aside with its flat side down flush on a bench so the edge is
not exposed.
Reinstall new knife in the reverse procedures outlined above.
Even though a new knife is very sharp, the sharpening procedure specified on pages 4 and
5 should be performed to true the new knife's bevel to the slicer.
Warning: Worn knife should be disposed of in a safe responsible way, showing concern for others
who may handle it.
It is recommended that the edge of the knife be wrapped several
times with heavy tape and that a caution (CAUTION: SHARP EDGE) be written on
both sides of the knife.
KNIFE SEAL
h.
Warning: Disconnect electrical power cord.
Remove knife per knife replacement instructions i through 6.
Remove pulley insert (Figure 3 [8]) by unscrewing. Retain shim washers if any.
Using a small screwdriver, carefully pry and remove the knife seal (Figure 3 [7] ) from
the knife pulley (Figure 3 [6] ).
Apply light film of Petro-Gel on outer diameter and lip of rubber seal.
Clean recess in pulley.
Drive seal into recess in pulley using care to avoid damage to seal. Seal should be seated
uniformly against recess shoulder.
Check pulley insert (Figure 3 [8] ) for small sharp burrs that may have been raised
during its removal. Remove burrs if present with a fine toothed file.
If burrs are not
removed, they will destroy the seal very quickly.
Page lO
6512
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor