Manual

6
Fig. n°13
Fig. n°12
2.2 - PLACEMENT
The machine and its related accessories must be kept in
a dry environment, far away from heat, humidity,
splashes, dust and anything else that might damage the
dipping blender and its accessories (Fig. 13).
The machine and its related accessories after having
been used must be placed on the special wall support
(Fig. 14 A).
In case the accessories are unused for a long time, they
might be stored in other places as long as these latter
respect the above-mentioned requirements and that they
guarantee good conservation of the accessories them-
selves (for instance, drawers that can bump the compo-
nents one against the other or cause them to fall must be
avoided).
The conditions will be the same even if no wall bearing
has been ordered.
Never position the dipping blender and the accessories
inside the suitcase unless they are perfectly dry.
Fixing the wall bearing (Fig. 14):
The wall where the bearing is to be fixed must be stable,
solid and must support he weight of the machine and its
related accessories.
Fix the wall bearing by means of pressure screws with
tassel of minimum 8mm diameter.
Position the wall bearing to a distance from the shelves
and/or tables which is sufficient to contain the accesso-
ries.
Position the wall bearing as per the instructions of chapter
2.2.
Positioning on the wall bearing (Fig. 14A)
Hook the engine’s body on the two right supports (of the
wall bearing) with the handle towards right. The highest
support inside the handle and the other outside beneath
the entry of the feeding cable.
Shaft and whip can be hooked on either the other two
spaces. The shaft is to be kept with the bell turned up-
wards, while the whip is to be kept as if operating.
Check that the bearings are always solid and parallel or
the correct support of the machine might be compro-
mised.
2.3 - ELECTRICAL CONNECTION
Check that the data reported on the register-technical
plate (Fig. 15) of the delivery documents match the deliv-
ery documents, if not please contact the supplier to have
an explanation.
Fig. n°15
Fig. n°14A
1
7
8
m
m
1
7
8
m
m
600 mm
Fig. n°14