Manual

21
CHAP. 7 - MAINTENANCE
7.1 - GENERAL INFORMATION
Before carrying out any maintenance task, it is recommended to:
unplug the feeding cable from the net to insulate the machine from the rest of the plant completely.
7.2 - DIPPING OF ACCIDENTAL FALL OF THE MACHINE
In case of immersion or accidental fall of any accessory or the machine itself, do not use it and contact CUSTOMER
SERVICE.
7.3 - SHAFT AND WHIP FIXING
Check that the shaft and the whip are firmly and solidly fixed to the engine’s body. If this is not the case, please contact
CUSTOMER SERVICE.
7.4 - FEEDING CABLE
Periodically, check the state of wear of the feeding cable and in case, contact CUSTOMER SERVICE.
7.5 - COMMANDS LINING
Periodically, check the state of wear of the rubber commands lining and in case of wear contact CUSTOMER SERVICE.
7.6 - BLADE
Check the sharpness of the shaft’s blades to replace them, please contact CUSTOMER SERVICE.
7.7 - WHIPS
Check that the whips keep their original conformation and that they do not detach easily from the whip’s body. If this is
not the case, please contact CUSTOMER SERVICE.
7.8 - GASKETS - SEALING RINGS
Periodically check the sealing gaskets, once the knife-holding base is disassembled (Fig. 64).
If these show wear, contact CUSTOMER SERVICE.
CHAP. 8 - DISPOSAL OF THE MACHINE
8.1 - DISINSTALLATION
If it has been decided to disinstall the machine for some reason, ensure that the machine is unusable by anyone: detach
and cut electrical connections.