Manual

17
As for the shaft, alternate the revolution even in the move-
ments from the top to the bottom to ease the entry of the
products to be cut in the operating bell (Fig. 48).
Work till the desired consistency is obtained, once fin-
ished using it, switch the machine off.
ATTENTION: Do not use the machine in free air and to
avoid any risk of physical or mechanical damage, never
extract the tool from the product while still rotating (Fig.
49).
ATTENTION: as a result of the centrifuge effect, the liquid
tends to rotate and to higher its level closer to the border
of the container, when the blender is functioning, hence
never fill the container over 2/3 of its capacity (Fig. 48).
Never carry out work cycles for over 10 minutes and keep
the blender switched off anyway for at least 10 minutes
between a work cycle and the next (Fig. 51).
At the end of the working cycle, remove the machine from
the working container and proceed immediately to the
cleaning of the tool (see chapter 6 Regular cleaning).
Never leave the machine unattended inside the con-
tainer.
Fig. n°48
Fig. n°49
Fig. n°50
Working cycles:
10 minutes ON – 10 minutes OFF
Fig. n°51