Manual

B6TTR-B10TTR – Page. 59
“COOL” – “WASH” – “FILL” PROGRAMMES:
The “Programmes” mode of the electronic control also contains some non-modifiable programmes.
These are stored in the firmware of the control itself and are independent from the 60 programmes
available for user customizing.
• “COOL” Programme:
allows you to cool the oven in a short time by operating the
fans also with the oven door open. Once cooled the cooking
chamber, press the key for 3 seconds to stop the
programme. In the event of chamber overtemperature
alarm, this programme is recalled automatically and
proposed for the execution.
• "WASHING" programmes:
• LAV1 – Delicate (42’)
• LAV2 – Normal (1h 04’)
• LAV3 – Intensive (1h 34’)
• LAV4 – Super-intensive (1h 56’)
These 4 programmes are provided for the washing group
and can be selected as needed.
• “FILL” Programme:
manages the filling of the pumps and hoses of the oven
washing system, at the first filling of the tanks or when the
tanks are changed. The programme has a duration of 2
minutes. Make sure the installation tubes are empty
before running the programme.
To select one of these programmes, proceed as follows:
• Press the key to enter the Programmes mode.
• Use the “-“ key to scroll through the menu until the programmes described above are
displayed. Select the desired programme and confirm by pressing the key
• Press the key to start the programme.
The end of the Wash and Fill programmes will be highlighted by the buzzer.
Attention:
Once the washing program is finished, absolutely unmount the rotating nozzle from the
oven’s chambre. DO NOT PROCEED IN ANY WAY COOKING WITH THE ROTATING NOZZLE
INSTALLED IN THE OVEN’S CHAMBER, OR IT’S GOING TO BE IRREPARABLY DAMAGED.