Manual

B6TTR-B10TTR – page. 73
Fig. 1 – Set the desired timers (max 59 minutes each),confirming each value with the button . After
having set the desired timers, scroll the remaining ones with the arrows buttons until the parameter
Temperature is visualized . After that, save all settings with the button . When the program
will start with the button , the timers will start counting (Fig. 2). The timer of a different colour will
be the first to end and will correspond to the tray number to be pulled out. At the end of each counting
the chamber lights light and the acoustic signal is activated. Open the door and pull out the tray.
ATTENTION: the baking with the next timer will start only when the door will be closed. If the
door will still be open, the oven will remain in stand-by.
During the baking program execution, it is posible to add other timers, modify the ones already set up, or
exit the Multi mode by pressing the button “Modify” .
In case the Multi mode needs to be canceled by the program (also in case of running baking),enter the
Settings menu and in the Time parameter scroll the Slider to pass from “Multi” mode to a specific
time.
EXECUTION OF A MANUAL PROGRAM
After having completed the Manual programming press the button to start the chosen baking
cycle. On the display following screen will appear:
When the program starts the icons in the bottom change and refer to the baking parameters.
These parameters are always modifiable also during the baking cycle.