Instruction manual

4509/451014512
OPERATORS CARE OF SLICER
Never touch the knife edge. Always keep your hands, fingers and
arms clear of knife.
Turn off slicer and DISCONNECT ELECTRICAL CORD before
cleaning. Leave protective guard (Fig. 1 [4]) in place,
Turn slice adjustment knob (Figure 1 [9]) to the fully closed position
(beyond "O") so that the knife edge is not exposed.
Remove carriage assembly (Figure 1 [5, 8, 11]) by loosening carriage
knob (Figure 1 [7]) and lifting off. Carriage may be washed in a
sink. Use care in washing the sharply pointed prongs on the last slice
device, (Figure 1 [5]). Wash this area thoroughly. A small bristle
brush is recommended. Use only warm water and mild soap. Rinse
carriage assembly with warm water and dry thoroughly using a clean
soft cloth.
Never use detergents or wash the slicer or any of its parts in a dish
washing machine or the clear protective finish will be damaged.
Warning
5.
Wash body of slicer using warm water and mild soap using a clean
soft cloth. Under no circumstances should the slicer be hose rinsed.
It is recommended that the cloth be folded over a thin wooden stick
when cleaning between the fence and the knife.
Remove knife guard (Figure 1 [3]) by loosening knife guard knob
(Figure 3 [11]) and pushing the long stud upward to lift knife guard
above surface of knife. Then carefully lift and remove guard.
Remove knife deflector (Fig. 3 [6]) by unscrewing screw (Fig. 3 [7]).
Warning:
8. CAREFULLY wash the front and rear of the knife with a cloth using
warm water and mild soap.
It is recommended that the cloth be
folded over a thin wooden stick as a further caution to avoid
accidental contact with the knife edge. CAREFULLY wash between
the knife edge and protective guard (Figure 1 [4]) using a soft cloth
inserted between knife edge and guard on both front and rear of knife
using extreme caution to never touch the knife edge. Rinse with
warm water applied with a cloth. Dry thoroughly with a clean soft
cloth.
Caution:
9.
Following cleaning, a commercial nontoxic sanitizer may be wiped on
the clean surfaces with a soft clean cloth or sprayed as recommended
on the container labeling.
It is important that the sanitizer be
compatible with anodized aluminum or the clear protective finish on
the slicer will be damaged. Surface should be wetted completely, but
not to the point of running or puddling.
Warning:
10.
Replace the knife guard. Never leave the slicer without its knife
guard installed!
11.
Replace knife deflector.
Page 6
CLEANING
Warning:
1.
Warning:
2.
3.
Caution:
4.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor