Instruction manual

4509/4510,4512
Honing (deburring) stone (Figure 8 [18)
) is removed by first unscrewing lock
screw (Figure 8 [14] ) from button (Figure 8
El 5]).
Gently remove button taking care to not lose the
small ball bearing and spring
(Figure 8 [16 & 17] ) which are inside.
Unscrew nut (Figure 8 [13] ) and
remove along with washer and honing stone
(Figure 8 [18] ).
Install new honing stone with the hollowed side
toward the inside.
Reattach cover and reinstall in the reverse procedures
(4. through 1.).
DRIVE BELT REPLACEMENT
WarnIng: Disconnect electrical power cord.
Remove knife per knife replacement instructions.
Remove four rubber suction feet (Figure 3 [4]
) that secure bottom cover (Figure
3 [29] ) to slicer. Remove cover.
Loosen nut (Figure 7 [2) ) on motor adjustment
screw (Figure 7 [1] ). Loosen
motor adjustment screw
Loosen set screws (Figure 7 [15 & 17]). Slide
motor pivot rod (Figure 7 [16)) to
the right (towards the blade) until left end of rod
disengages with base casting.
Page 11
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor