Terms and Conditions
VisionAR – VisionAR Terms and Conditions
Precautions and Recommendations– 7
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3.3 Battery
The following list details some battery related tips and warnings:
Recharge the battery at least once every 6 months to avoid battery degradation.
If the rechargeable battery is not used for a long time, we recommended to run the battery for a complete
cycle (100% charged to completely flat) a few times to ensure battery efficiency.
If the the battery performance decline significantly, the battery may have reached the end of its useful life
and must be properly disposed and replaced.
Charge the battery in an environment with a temperature range between 10°C and 30°C. The battery
efficiency may decrease if it is charged outside this temperature range.
Use only battery chargers approved by the manufacturer; using other chargers can: reduce the overall
battery life, cause battery fires, explosionsor the device malfunction.
Do not place the battery on heating devices such as ovens, stoves or radiators, or near devices that emit
electromagnetic waves such as microwave ovens as the battery could explode.
Do not exposing the batteries to very high or low temperatures.
3.4 Third Party Accessories
Third party accessories can be connected to the PPE to add additional functionalities, however the following must
be taken into consideration:
The accessory must be designed in such a way as not to affect the mechanical or electric components of the
device.
The accessory must not impact the function of the glasses or the face area protected by the glasses.
Before attaching an accessory verify that, if it detaches from the unit during use, this presents no risk.
3.5 Third Party Control Units
Third party Control Units can be used with the device but they must:
Only if connected via the USB cable provide by Univet s.r.l.
Third party Control Units must:
use the standard USB 2.0 hardware interface;
use a communication protocol which follows the frame buffer standard and the CDC defined and
limited by Univet s.r.l.;
be certified and marketed CE;
In order to maintain its safety status, the device must not be effected or altered by the Control Unit.
3.6 Control Unit Safety
The Control Unit manages voluntary and involuntary disconnections from the glasses thanks to a pre-installed
application. The application starts automatically on start-up.
The application works by:
tracking the last application in use;
Continuing to use the device in these conditions may result in fire or electric shock. Do not attempt to
repair, open or modify this product by yourself