Terms and Conditions

VisionAR – VisionAR Terms and Conditions
General Terms and Conditions– 5
•
•
•
•
•
•
•
2 General Terms and Conditions
You acknowledge, using this device, that its software and services are not intended or suitable for environments
where they could cause inaccuracies or delays in the information provided by the device, injury, death or damage to
the environment.
Univet S.r.l, within the limits of the law, declines responsibility for damages that may occur if the device is used in
unsuitable conditions.
Before using the PPE (Personal Protective Equipment) it is necessary:
Verify that the item meets your requirements (by reading this disclaimer)
Verify that the frame, lenses and display are not damaged or defective in any way that could compromise
visibility or their structural impact resistance. If they are damaged or defective, the glasses must not be used
and must be replaced
If the PPE is not completely assembled or if it is necessary to replace one or more of its components, for
example the visor and/or the nose pads, the components must be assembled following the instructions
provided in the box or in separate dedicated documentation
Verify that all components are assembled according to the instructions provided in the dedicated
documentation or box, if any, and make sure they have the required safety marks
Adjust the straps and fitting system so that the PPE cannot inadvertently move during use
The PPE must be worn from the first instance of exposure to risk if it is required by the regulations in force
for the relative PPE marking
Place the Control Unit 20cm/8inch far from body when powered on