Terms and Conditions

Via G.Prati, 87 - 25086 Rezzato ( BS ) - Italy
Tel. [phone]
Fax. [phone]
www.univet.it - [e-mail]
GENERAL TERMS AND CONDITIONS
You acknowledge, using this device, that its software and services are not intended or suitable for
environments where they could cause inaccuracies or delays in the information provided by the
device, injury, death or damage to the environment.
Univet S.r.l, within the limits of the law, declines responsibility for damages that may occur if the
device is used in unsuitable conditions.
Before using the PPE (Personal Protective Equipment) it is necessary:
- Verify that the item meets your requirements (by reading this disclaimer)
- Verify that the frame, lenses and display are not damaged or defective in any way that could
compromise visibility or their structural impact resistance. If they are damaged or defective,
the glasses must not be used and must be replaced
- If the PPE is not completely assembled or if it is necessary to replace one or more of its
components, for example the visor and/or the nose pads, the components must be
assembled following the instructions provided in the box or in separate dedicated
documentation
- Verify that all components are assembled according to the instructions provided in the
dedicated documentation or box, if any, and make sure they have the required safety marks
- Adjust the straps and fitting system so that the PPE cannot inadvertently move during use
- The PPE must be worn from the first instance of exposure to risk if it is required by the
regulations in force for the relative PPE marking