Technical data

Operation

4-39

P/N 7135049A

E 2007 Nordson Corporation

VBC_Siemens

Setup (Screen 3: e.g. Nordson Setup, Pressure

Sensor Setup)

NOTE: To be able to work on the parameter level, the password for level 2

(trained personnel) must first be entered.

Fig. 4-47 V19

NORDSON Setup

Only for Nordson employees with the Nordson password.

Pressure Sensor Setup

The keys can be used to select a certain pressure sensor.

NOTE: Pressure sensor A is always located at the melter outlet, behind the

filter cartridge (default). With the option Pressure display and pressure

control, it transmits the values to the motor controller.

Fig. 4-48 V20

NOTE: To calibrate the sensor, the melter must be heated to processing

temperature and may not be pressurized (relieve pressure if necessary;

refer to section Installation).

Calibrate

Perform nullification. Nullification should be performed even if

0 bar is displayed as the actual value; internal calibration is more

precise.

2. Activate connected pressure channels, thus enabling the pressure

display.

Range end

value

The pressure limit for every pressure sensor must be entered

for the correct pressure to be displayed.

Master Overwrite (Pressure)

The master overwrite key offers a way to enter all alarm values only

once and have them apply for all pressure channels.

Fig. 4-49 V20.1