Technical data

Operation
4-8
P/N 7135049A
E 2007 Nordson Corporation
VBC_Siemens
Control Panel Setup (contd.)
S Activate/deactivate channels
S Re-name temperature channels if necessary.
NOTE: Texts that the customer can change are not translated into
the selected local language.
Refer to Overview / T3.
S Pump speed(s) in manual mode
NOTE: To prevent excessive wear, the motor/pump speed should
not continuously fall below 5 min
-1
(rpm) or continuously exceed
80 min
-1
(rpm).
Refer to Overview / M1.
S If the melter is to be operated via the interface Standard I/O, change
the motor enable from Control panel to Control panel AND standard
I/O.
Refer to Overview / M2
S Key-to-line − settings
Refer to Overview / M1 to M3.
S Select temperature unit, °C (default) or °F
Select pressure unit, bar (default) or psi
Refer to Overview / V15