Installation manual

2/47
2
2.2
Communication modules are used to send I/O data from a Tego Power motor power-
starter configuration to the PLC.
The communication modules is selected according to the type of connection
required :
b in parallel mode (modules, terminal blocks or HE 10),
b or in serial mode on the bus (AS-i bus, Interbus S, Fipio, Profibus DP, CANopen
or DeviceNet modules).
The communication modules are the same, whether the TeSys motor power-starter
system uses spring or screw terminals.
Motor power-starters can be connected to a PLC or a bus in two ways :
b by direct connection from the control circuit splitter box
3 with 4 starters, with an
HE 10 connector (8I/8O) or two HE 10 connectors (16 I and 8 O),
b by a Tego Power module
1 using an APP-2CX adaptor plate 2 .
A module
4 is mounted by direct mechanical assembly on the modular sub-base ,
with no screws or accessories.
The electrical connection between the modular sub-base and the communication
module is made using an HE 10 connector.
Communication modules
General
Modules in a TeSys motor power-system with spring terminals
Modules in a TeSys motor power-starter system with screw terminals
1 32
4
Modicon TSX Micro
automation platform 0
Installation system
Tego Power for motor power-starter components
Presentation (continued)
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: [phone] ● www.stevenengineering.com
efesotomasyon - telemecanique inverter