Installation manual

2/45
2
2.2
P O N M L K J I H G F E D C B A
P O N M L K J I H G F E D C B A
APE1B230 Dialbase 16 points Ue = 230Vac
105
108
104
101
1
201
301
204
205
206
4
Q1
Q4
Other
products
AS-i Bus
Modicon TSX Micro
automation platform 2
Installation system
Tego Dial for Human-Machine interfaces
Standard connections
Tego Dial offers a range of interface components and
cabling accessories that simplify connections between
control and signalling units and PLCs, buses and other
products.
The main components which make up this range are :
v pr
efabricated connection cables and insulation
displacement connectors 1 , 5 mm pitch, for connecting
control and signalling units to Dialbase interfaces,
v Dialbase 8I/8O or 16I interfaces
2 with integrated
commons, for connecting control and signalling units to
PLCs via prefabricated Telefast connection cables
5 ,
v an active splitter block
7 for connecting a Dialbase 8I/
8O interface to PLCs with a connection modularity greater
than 8I/8O,
v a Dialbase 230 V interface
3 for connecting control and
signalling units to any product up to 230V,
v a Dialbase AS-i 4I/4O interface 4 with integrated commons,
for connecting control and signalling units to the AS-i bus.
The selection guide on page 2/40 indicates the type and
quantity of components (Dialbase interfaces, active splitter
block, Telefast connection cables) required to connect the
control and signalling units to the various types of PLC. The
most efficient connection is achieved using the Dialbase 8I/
8O interface and the Telemecanique TSX Micro PLC
TSX DMZ16DTK card 6.
Dialfix and Dialmove suspension arms
Dialpack control consoles can be fitted directly using 4
adjustable lugs, ref. AE3-FX122. However, for improved
ergonomy, they are usually mounted on a suspension arm.
This can either be fixed (Dialfix) or moving (Dialmove).
Dialfix fixed arms
Two versions are available :
v a straight fixed arm kit, comprising a straight Ø 70 mm
tube, 500 or 1000 mm in length, and a pair of clamps
(one for each end). Depending on the positioning of the
clamps, an inclination of ±15° from the natural position
can be achieved,
v an elbowed (90°) fixed arm kit, 500 mm in length. This
kit also includes the pair of clamps described above.
Arms for corrosive environments
The arms are in 304 type stainless steel and provide 350°
rotation on the Dialpack fixing side. Two models are
available:
v straight arm kit, length 1000 mm,
v 90° elbowed arm kit, length 500 mm.
Dialmove moving arm
This arm enables an extensive choice of mounting
configurations. The cabling runs through the elements,
which have removable side covers for easy access.
Numerous configuration possibilities can be achieved by
combining the following components:
v straight tubes (100 to 1000 mm long),
v fixed 90° joint,
v wall fixing bracket (straight or elbowed, fixed or mobile),
v straight fixing plates (one fixed, other rotating) for
Dialpack,
v 15° tilted joints,
v pivoting joint (-90° to +90° in the same plane).
Presentation
2
3
7
5
5
5
1
1
4
6
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: [phone] ● www.stevenengineering.com
efesotomasyon - telemecanique inverter