Specifications

40
PROBLEM:
G. The Main Logic Board
Display is showing a
“HopperX NoComm” Error
Message.
H. The changer is giving the
wrong payouts.
I. The bill validator’s red status
LED is on steady but it still
will not accept the bill.
FOR TECHNICAL SERVICE
OR TO OBTAIN A RETURN
AUTHORIZATION NUMBER
CALL [phone]
4
SOLUTION:
1. Check to see that the hopper is pushed all the way into the changer,
so that its 12-pin connector makes full contact with the connector on
the back of the hopper plate.
2. The hopper harness may be loose or unplugged; check the
continuity of the harness, and repair or replace if necessary.
3. The hopper may be plugged into the wrong connector. It should be
plugged in to the Left-side ccTalk connector on the MLB.
4. The hopper is faulty; repair or replace it.
1. The Main Logic Board’s user-programmed settings for changer
‘Mode’ and/or ‘Payout’ are incorrect. Refer to the section
“Programming the AC1005/AC2221 Series Changer” on pages 4-14
of this manual for detailed instructions on how to reprogram the
changer’s operation.
1. Pull out the lower housing, referring to pgs. 20 or 27 for
instructions, and look for something obstructing the bill path (i.e.
gum, papers, tickets, coins, etc.).
2. Open up and look inside the plastic Logic Board box on the side of
the bill validator. Ensure that all the wire harness plugs are plugged
firmly into their white female sockets.
ANY REPAIR RETURNED WITHOUT A
RETURN MATERIAL AUTHORIZATION
NUMBER (RMA#) WILL BE REFUSED!!
TROUBLESHOOTING GUIDE
TO USE THE TROUBLESHOOTING GUIDE, MATCH UP THE PROBLEM, THEN FOLLOW THE
SOLUTION SUGGESTIONS. After every step try operating the changer to see if the problem has been solved.