Specifications

1. COIN BOX REMOVAL

1. Place the hopper in front of you as shown, (looking at

the outside of the ‘coin box’).

Refer to FIG 1.

2. Remove the 2 locking nuts, which hold the ‘low level

sense plate’ wires to the studs.

3. Remove the crimp & wire from the studs.

Refer to FIG 1a.

4. Remove the 5 screws indicated (B), which hold the

‘coin box’ to the ‘center plate’.

5. Gently lift the ‘coin box’ away from the rest of the

hopper. (Refer to FIG 1b)

NOTE: The ‘logic board’ & ‘stirrer’ are

located in the ‘coin box’.

6. As the ‘coin box’ is being removed, carefully slide the

‘logic board’ out. The stirrer may stay with the ‘coin

box’ or fall onto the center plate.

ACCESS IS NOW AVAILABLE TO THE ‘LOW

LEVEL’ SENSE PLATES, THE MAIN PCB, THE

EXIT WINDOW, THE MOTOR TERMINALS &

PART OF THE WIRING LOOM.

1a. COIN BOX ASSEMBLY

1. Firstly, locate the ‘stirrer in the ‘coin box as shown in

FIG 12.