Specifications

18
VALIDATOR INTERFACES
18-PIN Interface Connector
PLUG KEY
Interfacing the CoinCo BA30SA with the
ValiChanger
Connect wires 4 & 12 (Black & Red) together on
the 18-pin connector to enable the Validator. If
the validator pulls the bill ½ way in and stops
change dipswitch #3 on the bill validator logic
board.
Interfacing with the MEI (Mars) AE2602
Series Validator
8-Position Switch
1 - off 5 - off
2 - off 6 - off
3 - off 7 - off
4 - off 8 - off
The 18-Pin interface connector is not needed.
Pyramid APEX 5400 Series and VTI Matrix
Series Interface Connector
Interfacing with the Pyramid APEX 5400
Series Validator
No DIP Switches. Validator can be factory
programmed, or it can be configured using the
Configuration Card or a Palm. Refer to the
validator’s Installation/Operation manual for
further information.
6-Pin (MDB) Connector Pinout:
Pin #1 - +24VDC Power
Pin #2 - DC Power return
Pin #3 - Not Used
Pin #4 - Master Receive
Pin #5 - Master Transmit
Pin #6 - Communications Common
Interfacing with the VTI Matrix Series
Validator
No DIP Switches. The validator’s bill acceptance
can be set using the push button on its rear
panel. Refer to the Installation/Operation manual
for further information.
6-Pin (MDB) Connector Pinout: (see previous)
Coinco MAG Series 6-Pin Interface
Connector
Interfacing with the Coinco MAG52SA
Validator (MDB)
8-Position Switch:
1 - off 5 - ON
2 - off 6 - ON
3 - ON 7 - ON
4 - ON 8 - ON
6-Pin Connector Pinout:
Pin #1 - Master Receive
Pin #2 - Ground
Pin #3 - Not Connected
Pin #4 - +24VDC Power
Pin #5 - Master Transmit
Pin #6 - Ground
Contact American Changer for use of the Coinco
MAG52SA Validator in Pulse mode.
Cashcode ST-03 Series Interface
Connector
Interfacing with the Cashcode ST-03 Series
Validator
8-Position Switch:
1 - ON 5 - off
2 - ON 6 - ON
3 - ON 7 - off
4 - ON 8 - off
Jumper between Pins 1 and 2 of JP2.
6-Pin (MDB) Connector Pinout: (see previous)
Pin #1
Pin #9
Pin #18
Pin #10
Pin #1
Pin #6
Locking
Tab