Specifications

17
12 pin female
connector
Motor
Coin counting optic
Hopper coin bin
(Dump the coins
into this hole;
1600 coins max.)
HOPPER COIN/TOKEN SIZES
The hopper will automatically adjust to dispense
coins/tokens in size from 20-30 mm in diameter
and 1.25 - 3.5 mm in thickness. There is an
option available to dispense smaller coins.
A nickel is approximately 21 mm, a quarter
is approximately 25mm, and a Susan B.
Anthony is approximately 28mm in
diameter.
MAIN LOGIC BOARD CONNECTOR
PIN DEFINITIONS
MDB Validator harness:
Connector J12
Pin #1 - +24 VDC
Pin #2 - Ground
Pin #3 - Data Pin, Master Transmit
Pin #4 - Data Pin, Master Receive
ccTalk Device Harnesses:
Left Side (Single Hopper) – J3
Right Side – J8
Pin #1 - Ground
Pin #2 - +24 VDC
Pin #3 - +5 VDC
Pin #4 - No Connection
Pin #5 - Data Line (Tx & Rx)
Pin #6 - Select (+24VDC) Right Only
Pin #7 - Ground
Compact Hopper harness:
Connector J1
Pin #1 - Motor Ground
Pin #2 - Motor Power (+24VDC)
Pin #3 - Chassis Ground
Pin #4 - Sensor A
Pin #5 - Low Coin Sensor
Pulse Device harness:
Connector J11
Pin #1 - +24VDC
Pin #2 - Bill In
Pin #3 - Fail
Pin #4 - Enable
Pin #5 - Ground
Pin #6 - Ground
“Out-of-Service” Light harness:
Connector J2
Pin #1 - +24 VDC
Pin #2 - Ground
COINCO BA30 SERIES ERROR CODES
Flash codes 1-18 may appear during normal
servicing of the BA30. If more than one error or
condition exists, the lower number flash code will
appear until its respective error or condition is
corrected. The left and right sensors referenced
below are given viewing the BA30 from the front.
# of Flashes
Description of Flash Codes
1 Bill box full
2 N/A
3 Check bill path
4 All bill accept switches are off
5 Bill jam or sensor error
6 Stacker motor/home sensor
7 Transport motor/encoder sensor
8 N/A
9 EEPROM Has Failed
10 RAM or ROM Has Failed
11 Center Optic Failed
12 Right Optic Failed
13 Left Optic Failed
14 Bill Position Sensor Error
15 Right Bill Position Sensor Error
16 Left Bill Position Sensor Error
17 Lower Anti-Stringing Armature out of
place
18 Upper Anti-Stringing Armature out of
place