Users Manual

Steps
5 / 6
According to the site requirements, drill a 32mm-diameter hole in the gate (commonly in
the middle or the front), as shown on the picture, is the suggested hole position.
Single-channel gate Dual-channel gate
50CM
Attention: Hole position should be decided by actual scenes and applied gate type,
50cm is the reference value only.
1
2
5
4
3
Attention: a) At this time, do not connect cables such as network cable and power cable, to avoid the trouble of installation.
b) Please thread the 4 cables out one by one, instead of threading all 4 cables together, as shown on the picture.
Screw off the fixing nut at the column bottom, thread the cables through the nut.
Insert the column and cables into the hole on the gate, from top to bottom.
At the gate bottom, thread the cable interfaces out the nut one by one, align the nut with
thread and then tighten.
Use hexagon screw tool or hexagon screw driver to
loosen the screw, adjust the angle and then tighten
Connect power and network cable, boot the device and display screen. Adjust the support
angle to reach the optimal recognition angle as well as optimal recognition height range.
Take down the nut
Tighten the nut
D00R_NC
D00R_N0
D00R_C0M
D00R_NC
D00R_N0
D00R_C0M
Hexagon wrench
Hexagon screw
Screwed hole
Hexagon wrench
Hexagon screw
Screwed hole
Plastic nut
Device