User`s guide

Page | 32
Note: Windows uses the Computer name, as shown on Control Panel - Network -
Identification, as the default Logon Name. But you can create a new Windows logon name
by merely entering a new name and password at the Logon prompt.
D. HOW TO DO A DIRECT U SB COPY
Scenario: Sometimes you may want to quickly transfer contents from a USB flash drive to your MYXERVER™ PRO without
using the computer.
1. Plug in the USB device into MyXerver™ Pro USB port. You can see your USB device status under Administration,
Maintenance, Disk Utility as follows;
2. Press the COPY button for 2~3 seconds, the contents of the USB storage device will be copied into MyXerver™ Pro.
During this copying process, the USB LED icon from front panel will be flashing.
3. After the data are copied over, disconnect the USB device safely. You can find the copied data under
\\myxerverpro\public\backup-Date folder as shown below.