User`s guide

44
access to data on the disk. (To see the results of the
Scandisk operation, use the "View Disk Log" button.)
 Completed - The last Scandisk operation has been
completed. You can use the "View Disk Log" button to view
the results.
 Terminated - The last Scandisk operation was cancelled by
the Administrator before it was completed.
Schedule
 Never - Scandisk will not be scheduled to run.
 Every Day - select this to have scandisk run each day, at the
specified time.
 Every Monday, Every Tuesday, ... - Select this to have the
scandisk run once per week, on the specified day.
 Use the time fields (hour, minute, am/pm) to specify when
the scandisk operation should be performed.
Start Button
Click the button to start the Scandisk. The Scandisk could take long time, and the disk is
unavailable to users while the Scandisk is in progress.
Stop Button
If a Scandisk is in progress, and you wish to stop it, click the Stop button.
S.M.A.R.T
Status
 Not Installed - No disk is available.
 Not Checked - No S.M.A.R.T. check has been performed on
this drive since system boots up.
 OK - No errors were found in the last test.
 Going to fail - The S.M.A.R.T. check found errors on the drive
and the disk is going to fail.
Schedule
 Never - S.M.A.R.T. check will not be scheduled to run.
 Every Day - Select this to have S.M.A.R.T. check to run each
day, at the specified time.
 Every Monday, Every Tuesday, ... - Select this to have the
scandisk run once per week, on the specified day.
 Use the time fields (hour, minute, am/pm ) to specify when
the S.M.A.R.T. check should be performed.
Check Button
Check - Click this button to run the S.M.A.R.T. check immediately.
Standby
Set Hard Disk to
Standby Mode
after
Idle 10 minutes – Set HDD to standby mode, if idle for 10 minutes
Idle 30 minutes – Set HDD to standby mode, if idle for 30 minutes
Other Buttons
Save Button
Click it to save the modifications in this window
Cancel Button
Restore the settings on the screen to their values after the last "Save" operation. Clicking
"Cancel" has NO EFFECT on any operations in progress.
View Log Button
View the log messages of disk maintenance